USE AT YOUR OWN RISK!!
Insert this program into the NC memory area of the control.
When you run this program it will automatically measure the current tool in the spindle (allows the use of D numbers as well). If it is the first time you are measuring a particular tool you must first give it a rough length in the offset table.
Insert this program into the NC memory area of the control.
When you run this program it will automatically measure the current tool in the spindle (allows the use of D numbers as well). If it is the first time you are measuring a particular tool you must first give it a rough length in the offset table.
| measurecurrenttoollength.mpf |
