- Store
- >
- Pick and Place (PnP)
- >
- Buy my old pick and place head!!
Buy my old pick and place head!!
SKU:
$243.00
$149.00
$149.00
Unavailable
per item
I've upgraded the head on my pick and place to the latest version so I am selling the old one. Differences from the current version are as follows:
- Roller snap action limit switch instead of inductive proximity switch for homing Z. The same smoothie firmware works for this setup.
- No machined reference edges for the Z rails (however the "drill holes" were very accurately placed with a 5 axis waterjet so they are quite parallel).
- 3D printed ELP camera mount, which I will include. ELP camera not included.
I will also include the 3D printed vacuum adaptors for 4mm push to connect tubing as seen in the pictures.
Comes with everything you see in the pictures. If you also buy juki nozzle holders I will set them on the motor shafts and adjust to below 0.001" total indicated run-out at the end of the holder.
- Roller snap action limit switch instead of inductive proximity switch for homing Z. The same smoothie firmware works for this setup.
- No machined reference edges for the Z rails (however the "drill holes" were very accurately placed with a 5 axis waterjet so they are quite parallel).
- 3D printed ELP camera mount, which I will include. ELP camera not included.
I will also include the 3D printed vacuum adaptors for 4mm push to connect tubing as seen in the pictures.
Comes with everything you see in the pictures. If you also buy juki nozzle holders I will set them on the motor shafts and adjust to below 0.001" total indicated run-out at the end of the holder.
Sold Out
Prices in US Dollars